Ryaan Tuttle

Jan 6, 2025 | wikihow.com | Ryaan Tuttle

1Clean all dust and debris from the floor. The pine flooring should be completely clean of all dust, dirt, and small rocks. Depending on the size of your flooring, run a damp mop or a rag over the surface of the floor. Make sure to clean in the corners of the room and remove dust from any nooks or crannies. If your floor has just been installed, it won’t be covered in outside dirt. Instead, you’ll need to mop off leftover sawdust from the installation process.

Nov 25, 2024 | wikihow.com | Raven Minyard |Ryaan Tuttle

Download Article Easy DIY solutions to keep your garage door working safely & correctly Download Article All garage doors come with a set of sensors to ensure they open and close safely. When the sensors’ lights are green, everything is functioning properly, but when they turn yellow, the sensors aren’t communicating correctly. In this article, we’ll teach you everything you need to know about yellow garage door sensor lights, including what they mean and how to fix them.

Oct 28, 2024 | wikihow.com | Ryaan Tuttle |Devin McSween

Download Article Easy ways to remove wet or dried silicone caulk from your skin Download Article Silicone caulk is a great tool for filling gaps and making the seal waterproof. Unfortunately, these same properties can make it hard to remove when it gets on your hands. Luckily, there are lots of simple home remedies to get off fresh and dried caulk, like rubbing your hands with a plastic bag, rubbing alcohol, or butter and baking soda.

Oct 7, 2024 | wikihow.com | Kyle Hall |Ryaan Tuttle |Dan Hickey

Download Article The best tools to cut through screws and bolts of any diameter Download Article Home repairs can hit a major snag if the screws you have are too long for the job! You can always stop what you're doing and make a trip to the hardware store to buy smaller screws, but if you're in the middle of a project, this can be inconvenient. You can't leave the ends of screws pointing out, and the easiest solution is to cut them with a wire stripper.

Jul 25, 2024 | wikihow.com | Ryaan Tuttle |Raven Minyard

1Locate the “Learn” button on your garage door opener. The “Learn” button is what allows the garage door opener to connect with remotes, keypads, and other features. The exact appearance and size varies from model to model, but in general, it’s a small yellow button located on the back or side of the unit. Refer to your owner’s manual if you have trouble finding it.[1] For wall control units, the learn button is on the wall control panel. Some “Learn” buttons may be purple, red, green, or orange.